Page 1 of 1


Posted: Mon Jul 27, 2015 2:00 am
by crervear
hello, greetings, I have a problem when processing a file post feeler machine
TopSolid edges in the sharp visualize., but the post-processing file the rounded edges.
That will be what is wrong?
I need your help ...

Thanks in advance

Re: Edges

Posted: Mon Jul 27, 2015 1:20 pm
by Mark Oostveen
Are you using cutter compensation original or compensated mode? If yes show me the NC-code. It is well possible that it is not the NC code but the machine which rounds the corners.

Grz Mark