Page 1 of 1

Bug - check clash

Posted: Tue Jun 26, 2007 12:03 pm
by digital
TopSolid version: 6.7 (318).

Does anyone else have the following problem:

When I use "check clash" function, and when a clash has been found, the function hides every other electrode (visible=off), so that I can see where the clash has been found.

Now, when I'm done with using this function (erase results), I switch on another layer (where I had another electrode), but the electrode was set to INVISIBLE.

This happens to every other electrode in the working file...

A bug or?