Hello,
I have noticed an issue with sprue bushings.
I selected a DME 6604-O_5/32-R_1/2
The "O" is incorrect.
The DME catalog shows the "O" dimension at the bottom of the spherical nozzle radius.
TopSolid's user interface shows the dimension coming from the opposite end of the sprue bushing but even worse the dimension is not correct at either end. TopSolid is reporting the "d1" as .1562 but analyzing the component shows that the small end is .116 and the large end is .266 (trimmed length). The worst part of this is that I cannot edit the "d1" dimension because it is greyed out.
DME Sprue Bushings WRONG
Moderators: remi77, jacs, Daniel
Sprue "o" dimension
I found if you click on the d1 in the box to the right, it will let you change the "O" dimension. Not sure why but I have been doing this for some time.
Tim Rietsma
Contour Tool and Eng.
Contour Tool and Eng.