Page 1 of 1
[Solved] draft analysis
Posted: Thu Mar 08, 2007 4:54 pm
by Matt Berube
This picture is from the "create a mold with TopSolid Mold" video on the
www.TopSolid.com website. How do I perform the draft analysis as shown in this picture ? When I use PART, DRAFT I get a different result.
Posted: Thu Mar 08, 2007 6:26 pm
by jehronimo
Hi,
you just have to use the
Analyze | Normal function, and go in Draft mode....
The TopSolid'Mold draft analysis works only to measure the correct angle of a specific face, and to check the faces that are included between 0 and the value you entered
Jehronimo
Posted: Thu Mar 08, 2007 6:37 pm
by Matt Berube
Thank you very much.
That is exactly what I needed !
Posted: Sat Aug 18, 2007 8:15 pm
by protopart
can you give me an example of how this function would be used with the draft function not turned on?
i see how it is informative but not how it is useful...
thanks
keith