http://forum.TopSolid.fr/viewtopic.php?p=3166#3166
This is a link to the French Forum to refer to all picture
Does someone have the same problem with thread visualisation when you cut an assembly thru the center of a bolt (mist thread line on the bolt only in threded insert) For me it come from screw lib from mold bcs bolt from TS is OK I'm V240
Nedd feed back from mold designer
Screw section
Moderators: remi77, jacs, Daniel
- RICHARD LALONDE
- Sergeant
- Posts: 68
- Joined: Fri Feb 23, 2007 2:07 pm
- Location: Montreal
- Contact:
- RICHARD LALONDE
- Sergeant
- Posts: 68
- Joined: Fri Feb 23, 2007 2:07 pm
- Location: Montreal
- Contact:
patch
I'm lucky because I could discuss on both forum,
The answer is Missler know about this problem and they working on that, we are sure they will be ablee to resolve everything for next release 6.9
But I got some promess than everything will be fix may be with a single bolt library for all module in release VX (7.0)
What is amazing is this was working good before and now for unknow reason it turn in a bug, from my experience that happen often specialy in the mold modul some stuff work and in the next version it doen't work in the second next version they fix it. It's a pin in a bud
For your tapping hole it should be in inch (for me it works good ) may be your document properties unit is set mm
The answer is Missler know about this problem and they working on that, we are sure they will be ablee to resolve everything for next release 6.9
But I got some promess than everything will be fix may be with a single bolt library for all module in release VX (7.0)
What is amazing is this was working good before and now for unknow reason it turn in a bug, from my experience that happen often specialy in the mold modul some stuff work and in the next version it doen't work in the second next version they fix it. It's a pin in a bud
For your tapping hole it should be in inch (for me it works good ) may be your document properties unit is set mm