TopSolid'Forum

Hello Viktor,

Instead of snap center, please just try to use this way:

1)curve\other curves\circle\circle 3points
2)right click on the circle, you get the center

could it be useful for you?

jehronimo

Hello, it is not especially a "good" idea to keep your config from TS2006 to TS2008. Sometimes, some keywords are also obsolete, and can make give you some conflict in the use of your software. If you are using a x64 system, you can also have some trouble with the sentinel driver, especial...

Pieter is right, Almost all the attachments you are asking for already exists in TopSolid...I strongly recommend you to go in Tools | Options and ask for the Middle points in Picking ... Perpendiculer is existing, tangent is on automatically if you are drawing a line to a circle, center is ok with t...

Yessss!!

Same question than Olaio, it is a TopSolid render result?

Hi, So you have installed the Arial font from another PC? If you used the windows installation, you are sure that the font is now OK. But what happens in TS? The problem is that you need to set in a lot of place the current font. In the below toolbar (TxH=...) and in Tools | Options | Other | Defaul...

Hi Robert,

It seems to be a tangency problem, but what is the operation you are trying to do? A triming one?Can you send a file?

Jehronimo

Hi, You are wrong, the purge is not only a good solution for a finished work. You can use it during your design, but to be efficient, you also need to manage operation to keep in memory before the use of the purge. For example, you have a subtract operation, then 30 drilling operations for a cooling...

Hi,

I have seen the v610 at Missler , and we will be able to select ... by free curve and this is very cool...

Jehronimo

Hi,

I think you do not hav the correct patch installation, because I have no problem with the patch 6.9.240...that also fixed your first problem.

Jehronimo

Hi,

Maybe you can try this one:

Start a new TopSolid
Cancel the Opening windows
In the 3 menus, select Windows Reset Configurations
Close TS
Start it again

Is it better?

Jehronimo

Hi,

Jeff is right, and of course Quadro range makes good products, but TS does not use it @ 100%....so it is a lot of money for nothing (Mark, it is you? )...so it is always a better idea to buy a powerful GForce than a bad Quadro....

Jehronimo

Hi,

I guess you must ask an enhancement request, because we can not customize the cooling tool bar with this function (and the copy is also not available ...)

Jehronimo

Hi, I think that what you are trying to design it is impossible, and you will always get a "small" edges or faces problems at the end of your fillet. Because you can not design the swept curve with the upper section that is tangent to the lower one (once you have make a first 360° turn). ...

Hi,

I think your section curve is not good and contains a "wrong intermediate" point in its path...Am I wrong?

Jehronimo

Hi Everything else on Vista works just fine. It's a genuine Vista supplied with HP. I can't literaly tell you what the report is, because Vista is in my native language, and not english. It's something like this: " The program failed to load, because its parallel architecture it not right/corre...