Drawing, bill of material, 2D design, dimensioning, labeling, tolerances, symbols, title blocks...

Moderators: remi77, Daniel, jacs

Private First Class
Private First Class
Posts: 13
Joined: Sat Jul 19, 2008 2:58 am
Location: San Leandro, California


Unread post by kiwdwks » Sun Aug 14, 2011 11:14 pm

Can anyone please advise me? For some reason the text and dimensions in my bom are running vertically instead of horizontally along the width of my bom columns. Since there is not enough room in the height, all the text and dimensions are not readable (scrunched together). I'll attach a pic to show what is happening. I can't seem to find any place to control the orientation of the bom text.

This is something new with this document. If I go to a previous job and add a new bom there, it works fine there.

Thank you,
Picture of the problem with my BOM.

Post Reply

Who is online

Users browsing this forum: No registered users and 0 guests