Reding material from catalogue code

Product design in 3D, mechanical engineering, kinematics, dynamics, parts and components, surfacic, assemblies...

Moderators: remi77, jacs, Daniel

Post Reply
DamianCz
Private
Private
Posts: 2
Joined: Wed May 02, 2018 1:16 pm
TopSolid Module: TopSolid'Wood
TopSolid Version: 6.17

Reding material from catalogue code

Post by DamianCz » Thu May 03, 2018 11:37 am

Hi Gents,

I need to read material from catalogue code i got 3 part component and the reason i need this is that 1 of the component does pocket operation on the other so replacing it with new file is not an option as the operation is gone (i tried it already).

1st sub component (driver block)
- shape
- 2nd sub component (driver block)
- pocket operation
3rd sub component (driver block)

main file (driver block)
- 1&2&3 sub components put together
- publishing defined
- component parameters joined between them

I believe i should use "$material" but i don't know how to put material destination in there. Any suggestions how to do that?

Regards

Post Reply

Who is online

Users browsing this forum: No registered users and 0 guests