Is there a way to change the default thickness of a constrained block?
WHen woking in inches it defaults to 0.7" I would like it to be 0.75"
Default Constrained Block Thickness
Moderators: remi77, jacs, Daniel
- kerns
- Private
- Posts: 6
- Joined: Fri May 05, 2017 8:20 am
- TopSolid Module: TopSolid'Wood
- TopSolid Version: 6.18
- Contact:
Default Constrained Block Thickness
Last edited by kerns on Wed Mar 28, 2018 4:52 pm, edited 1 time in total.
-
- Second Officer Cadet
- Posts: 209
- Joined: Wed Dec 30, 2015 11:25 am
- TopSolid Module: TopSolid'Wood
- TopSolid Version: 6.20
- Contact:
Re: Default Constrained Block Thickness
Add a line in your top.cfg, or possibly $TOPCONFIG\V6XX\topzwoo.cfg
D_SH_BLOCK_CONSTRAINT_THICKNESS 0.75
Check Your numbers
RM
D_SH_BLOCK_CONSTRAINT_THICKNESS 0.75
Check Your numbers
RM
-
- Sergeant
- Posts: 62
- Joined: Fri Jul 08, 2016 5:12 pm
- TopSolid Module: TopSolid'Wood
- TopSolid Version: 6.20
Re: Default Constrained Block Thickness
Thanks for the tip RM!
For me, I had to make the change in my top.cfg file.
Also, everything in my file is metric which it converts to imperial so I had to set the value to 0.01905 (19.05mm)
For me, I had to make the change in my top.cfg file.
Also, everything in my file is metric which it converts to imperial so I had to set the value to 0.01905 (19.05mm)
Ken Hale
- kerns
- Private
- Posts: 6
- Joined: Fri May 05, 2017 8:20 am
- TopSolid Module: TopSolid'Wood
- TopSolid Version: 6.18
- Contact:
Re: Default Constrained Block Thickness
Thank You RaudMees! That saves a step!