Can anyone please advise me? For some reason the text and dimensions in my bom are running vertically instead of horizontally along the width of my bom columns. Since there is not enough room in the height, all the text and dimensions are not readable (scrunched together). I'll attach a pic to show what is happening. I can't seem to find any place to control the orientation of the bom text.
This is something new with this document. If I go to a previous job and add a new bom there, it works fine there.
Drawing, bill of material, 2D design, dimensioning, labeling, tolerances, symbols, title blocks...
1 post • Page 1 of 1
Who is online
Users browsing this forum: No registered users and 0 guests