Generate ISOFILE to Robocut Machines using PARAMETER "E

CAM Solution for wire EDM: calculation of gaps and prolongation of surfaces, machining based on profiles or surfaces, optimized tool paths,
2 to 4-axis-machining for all machines, DMIS...

Moderators: remi77, Daniel, jacs

Post Reply
f.paschoal
Private
Private
Posts: 2
Joined: Tue Jun 12, 2007 7:39 pm
Location: São Paulo
Contact:

Generate ISOFILE to Robocut Machines using PARAMETER "E

Post by f.paschoal » Thu Aug 28, 2008 12:16 pm

Hi,

I' like to kown if someone already used Paramenter "E" like E501, E502 on ISOFile for Robocut 510 machine?
Is it Possible to use this kind of Pp or How can I format it?

thanks,


:(

Post Reply

Who is online

Users browsing this forum: No registered users and 0 guests