BOM

Drawing, bill of material, 2D design, dimensioning, labeling, tolerances, symbols, title blocks...

Moderators: remi77, Daniel, jacs

Post Reply
kiwdwks
Private
Private
Posts: 8
Joined: Sat Jul 19, 2008 2:58 am
Location: San Leandro, California
Contact:

BOM

Post by kiwdwks » Sun Aug 14, 2011 11:14 pm

Can anyone please advise me? For some reason the text and dimensions in my bom are running vertically instead of horizontally along the width of my bom columns. Since there is not enough room in the height, all the text and dimensions are not readable (scrunched together). I'll attach a pic to show what is happening. I can't seem to find any place to control the orientation of the bom text.

This is something new with this document. If I go to a previous job and add a new bom there, it works fine there.

Thank you,
Mark
Attachments
bom.JPG
Picture of the problem with my BOM.

Post Reply

Who is online

Users browsing this forum: No registered users and 1 guest