Page 1 of 1
Dimension text
Posted: Mon Mar 09, 2015 5:55 pm
by CAD_73
I can't seem to find a way to have my dimension text vertical (parallel to the dimension Lines) instead of the standar horizontal way.
Re: Dimension text
Posted: Tue Mar 10, 2015 12:30 pm
by Mark Oostveen
I think it is the standard to make the text parallel to the dim. line. So can you show in a picture what you problem is?
Regards
Mark
Re: Dimension text
Posted: Tue Mar 10, 2015 7:13 pm
by CAD_73
- TopSolid
Wrong
- AutoCAD 3D
Dimension text
Posted: Wed Mar 11, 2015 8:27 am
by Mark Oostveen
Do you use à template? Is yes which one? If no what selection do you make in terms of the standard?
Grz
Mark
Re: Dimension text
Posted: Wed Mar 11, 2015 6:17 pm
by CAD_73
Hi Mark,
For now I wasn’t using any template.
I’m trying to create my own template
but this is one of the things I couldn’t change.
When I use Free A3 Horizontal mm the text is vertically reading, but still I want my dimension in the middle of the line, not above the line
Re: Dimension text
Posted: Thu Mar 12, 2015 8:51 am
by Mark Oostveen
That' s not a problem. This setting you can find in either the application options (Tools-options-dimension) or in the document properties (file-properties) if you find it in this last one you have to set it when your template is empty and open. Set the setting and save your template in config\template
Good luck
Mark
Re: Dimension text
Posted: Fri Mar 13, 2015 4:20 pm
by steveforrest
Hi. When I have been creating a draft document. I set the text direction with Tools-Dimension Style-Advanced Options then check box Text Direction and highlite what I want for length and angle.
Steve.
TopSolid 7.8
Re: Dimension text
Posted: Mon Mar 16, 2015 1:09 pm
by Mark Oostveen
Yes but we are talking version 6.14 not version 7.x [emoji3]
Re: Dimension text
Posted: Mon Mar 16, 2015 6:19 pm
by steveforrest
Ahh my bad, I did wonder.
Steve
Re: Dimension text
Posted: Sun Dec 20, 2015 11:30 am
by CAD_73
Still havn't found the right way
When using the Modify Element (wrench tool) I can change it like the PrintScreen. But when using Tools>Options>Dimensions there is no such option.