Page 1 of 1
Mirror parts
Posted: Wed Oct 14, 2015 10:59 am
by Erik Davidson
Hi,
Is there a way to mirror parts / components in a fast way? When you repeat parts in an assembly with mirror you en up with mirrored parts but I haven't found away to do this on a single part to quickly create a mirror of a part. I have tried edit / transform but to no luck. Anyone have any ideas?
Re: Mirror parts
Posted: Wed Oct 14, 2015 3:40 pm
by Mark Oostveen
What is you real problem? That you can't select a single shape in a multi shape component?
Re: Mirror parts
Posted: Wed Oct 14, 2015 5:40 pm
by Erik Davidson
Hi,
No. I would like to make a mirror of a whole assembly. This is possible when I mirror stuff in a repeat process with simple or double mirror but then the assemblies are connected to each other which complicates further work. I would like to be able to mirror a singe assembly and create a mirrored version of that assembly.
Re: Mirror parts
Posted: Wed Oct 14, 2015 5:53 pm
by Mark Oostveen
So just save as and than mirror. Or?......
You might try to use. Shape, transform, mirror
(Asuming you use TopSolid V6)
Re: Mirror parts
Posted: Wed Nov 18, 2015 8:30 pm
by Todd
you need to you duplicate--- then mirror and follow existing operations
Re: Mirror parts
Posted: Thu Nov 19, 2015 8:21 am
by remi77
Hello
In some cases, you can even create a mirror part (any transformation you want), then you create a new alternative set with your mirrored part only.
See you
Rémi