It is not possible put negative stock to leave on bottom in 2D automatic milling operation using slot mill.
It is not possible put negative stock to leave on bottom and on side in roughing , finish and in some others operations using this cutter .
Please do something with this.
Negative stock to leave with slot mill (CAM)
Moderators: remi77, jacs, Daniel
- flavio_ruivo
- Master Corporal
- Posts: 32
- Joined: Thu Mar 01, 2007 12:09 pm
- TopSolid Module: TopSolid'Cam
- TopSolid Version: 7.6
- Location: Leiria-Portugal
- Contact:
It's normal :(
Hi,
TopSolid'Cam and many others CAM softwares have the same problem!!
The sum (stock to leave+radius tool) must be>=0
If you need to put side offset you can change the diameter of tool, ( for ex. the tool have diam=10 and if you put 9.9 this take 0.5 per side)
TopSolid'Cam and many others CAM softwares have the same problem!!
The sum (stock to leave+radius tool) must be>=0
If you need to put side offset you can change the diameter of tool, ( for ex. the tool have diam=10 and if you put 9.9 this take 0.5 per side)