DELETING AN ACTIVE COORDINATE SYS

Proposals and Suggestions for new features in TopSolid.

Moderators: remi77, jacs, Daniel

Post Reply
Top'Noob
First Officer Cadet
First Officer Cadet
Posts: 245
Joined: Fri Jun 15, 2007 3:05 pm

DELETING AN ACTIVE COORDINATE SYS

Unread post by Top'Noob »

Hello,

Currently if we try to delete the active coordinate system the error message says "No element to delete". This message is absurd and confusing. :evil:

I propose 2 possible solutions...

1. Allow us to delete the active Coordinate System (the system should switch to the "Absolute CS" upon deletion)

2. If #1 is unacceptable then at the very least change the message to something like "cannot delete ACTIVE CS"
Top
User avatar
remi77
Administator
Administator
Posts: 348
Joined: Thu Feb 22, 2007 10:05 am
Contact:
Contact remi77

Unread post by remi77 »

Hi Top 'Noob

Yes, this is a fine remark :wink:

See you

Rémi :wink:
Top
User avatar
jehronimo
Major
Major
Posts: 149
Joined: Thu Mar 01, 2007 1:05 pm

Unread post by jehronimo »

Hi,

I am not sure this kind of behavior would be a good idea... :?

I mean that a lot of customers are not so high-skilled as you, and maybe they would not understand that delete the current coordinate system will also break all the associativity of the linked elements...

Of course the message is not so "correct", it is a common message. I figure that it would be difficult to get a message for each elements you want to manage, why the generic message.

jehronimo
Top
Post Reply

Return to “Suggestions and Enhancements”