Explanation of Machining Component Wizard

Everything about new TopSolid'Cam 7 software.

Moderators: remi77, Daniel, Bill

Post Reply
User avatar
michelle
Sergeant
Sergeant
Posts: 56
Joined: Sun Sep 20, 2009 7:45 pm
TopSolid Version: 7.8

Explanation of Machining Component Wizard

Post by michelle » Wed Oct 11, 2017 1:04 pm

Hi there,

I'm working through a tutorial TopSolid.TG.Cam.Tools.v7.10.Us.pdf. On page 11 of this tutorial I am busy stepping through the Tools>Functions>TopSolid CAM Wizards > Machining Component Wizard.. I am currently on the step as shown in the screenshot below.

I don't really understand this step at all. Could anyone refer me to somewhere in the help manual (or anywhere else) where I can read up on Tool Offsets for Center and Tip? If not, these are the settings where I don't understand their use and therefor I am not sure of what to set them to and their resulting implications.

1. "Respect Direction"?
2. "offset 3d" and "offset 2d"?
3. Plane compensation?
4. Point compensation?

5. The difference between "Center" and "Tip"

What I am really wanting is an explanation... however I cannot find anything in the help files. Please if anyone has a thorough understanding of this page could you please enlighten me with an explanation?
Tutorial_Screenshot.png

Thanks in advance,
Michelle

Post Reply

Who is online

Users browsing this forum: No registered users and 2 guests