Page 1 of 1

Adveon Beta 1.5.0.66 Install

Posted: Sat Apr 30, 2016 1:31 am
by axsyscnc
Hi there,

I've installed this beta, but it shows no CAM gateways, and returns the error "There is no license available for module "Tool Library". Please wait a few minutes and try again."

I've performed a repair on the Adveon installation, but the error persists. This is V7.10. It was working fine for the previous version of Adveon and V7.8 and 7.9

Re: Adveon Beta 1.5.0.66 Install

Posted: Sat Apr 30, 2016 2:29 am
by axsyscnc
Ok, it looks like I have fixed the issue.

By default, the Adveon install didn't install the TopSolid 7.9 and 7.10 Gateways. So, post install, I went to Control Panel -> Programs and Features -> Adveon. Right clicked, and chose "Change", and then clicked "Add Components". the Components TopSolid 7.9 and 7.10 Gateways are shown as available to install, so I proceeded to install them.

And now Adveon works as expected.

There sure is a lack of information about this application though, especially troubleshooting...