Milling in the center axis

Everything about new TopSolid'Cam 7 software.

Moderators: remi77, Daniel, Bill

SnakeCZCOM
Private
Private
Posts: 4
Joined: Sat Jun 30, 2018 6:49 am
TopSolid Module: TopSolid'Cam
TopSolid Version: 6.26

Milling in the center axis

Unread post by SnakeCZCOM »

Hello
I apologize in advance for my English.
I have a problem in milling the excentric grooves on the circumference of the cylinder. When milling I need the cutter to be in the center of the piece axis (Y = 0). However, when generating a trajectory, the tool goes out of the axis (Y = 5 and Y = -5). I have disabled the OffCenter feature.
Can it be that, the groove is eccentric? Is it possible to adjust the tool to the center of the axis?
Thank you
Attachments
milling in the center axis2.png
milling in the center axis1.png
milling in the center axis.png
SnakeCZCOM
Private
Private
Posts: 4
Joined: Sat Jun 30, 2018 6:49 am
TopSolid Module: TopSolid'Cam
TopSolid Version: 6.26

Re: Milling in the center axis

Unread post by SnakeCZCOM »

...
Attachments
milling in the center axis4.png
milling in the center axis3.png
Post Reply