Operation analysis
Posted: Mon Jun 19, 2017 4:10 pm
Hello all,
I have question about CAM operation analysis. I’m working on project with big number of unique parts. Each part has irregular shape holes (number of holes is about 400-500). These holes were made as “through one” pocket and this pocket was based on multi-selected curves. And so, in general terms, the question is:
I create the part with pockets A and B.
Pocket A is based on single curve. Pocket B is based on few curves (multi-selection of curves).
Then I try to recognize these pockets by “operation analysis on the part” in the CAM module and to machine them automatically. Single-curve pocket doesn’t make me problem but muti-curves one fails – only one of its holes is machined.
Is there a way to solve this problem?
Thanks,
With best regards, Vladimir.
I have question about CAM operation analysis. I’m working on project with big number of unique parts. Each part has irregular shape holes (number of holes is about 400-500). These holes were made as “through one” pocket and this pocket was based on multi-selected curves. And so, in general terms, the question is:
I create the part with pockets A and B.
Pocket A is based on single curve. Pocket B is based on few curves (multi-selection of curves).
Then I try to recognize these pockets by “operation analysis on the part” in the CAM module and to machine them automatically. Single-curve pocket doesn’t make me problem but muti-curves one fails – only one of its holes is machined.
Is there a way to solve this problem?
Thanks,
With best regards, Vladimir.