hello i am jeff from the U.S / thank you missler

jeff · Unread post by **jeff** » Fri Feb 23, 2007 6:21 pm

hello fellow wood workers and wood products manufactures, i am jeff from the U.S, i thank missler for creating this forum and look forward to talking with other wood workers that are using TopSolid or thinking of using TopSolid. is there anyone else out there??? can anyone tell me if there is a way to set a default mortise clearance? i can not seem to find this in the properties. thanks all

Pieter · Unread post by **Pieter** » Mon Mar 12, 2007 1:43 pm

Hello,

The only way (I know off) is to create a model. He will remember your values, you can allways addapt on application if neccessary.

Hope this helps.

Regards

jeff · Unread post by **jeff** » Tue Mar 13, 2007 12:50 am

thanks pieter, i found out that this is not supported in 6.7 but is a new function in 6.8 which we should have soon. are you a woodworker?

Pieter · Unread post by **Pieter** » Wed Mar 14, 2007 12:44 pm

Hello,

These features also exist in 6.7! when selecting the tenon type, you can create a model.
I'm a reseller of TopSolid, I do several modules, but I am more or less specialised in the wood-woodCAM module.

Regards

Pieter

jeff · Unread post by **jeff** » Wed Mar 14, 2007 2:00 pm

what i am referring to is when creating a mortise from a tenon you are prompted to enter a tolerance value, when doing several of these operations entering the same value is a little time consuming, in 6.8 when making a mortise from a tenon the tolerance value is carried from the tenon model. thanks pieter

Pieter · Unread post by **Pieter** » Mon Mar 19, 2007 12:04 pm

Oh, OK.

Sorry for the misunderstanding.

Regards