CADCAM machining solution: mill-turn centers, milling and turning, kinematics, fixtures, topology recognition, tool library, manufacturing schedules, realistic simulation, workshop sheets, post-processors and DNC...
Moderators: remi77, jacs, Daniel
-
kotlas
- Corporal
- Posts: 21
- Joined: Fri Jan 14, 2011 6:53 am
Unread post
by kotlas »
Hello
Can I add some function to this list?
-
Attachments
-
-
remi77
- Administator
- Posts: 348
- Joined: Thu Feb 22, 2007 10:05 am
-
Contact:
Unread post
by remi77 »
Hi Kotlas,
No, it's impossible to complete this list,
See you,
Rémi
-
kotlas
- Corporal
- Posts: 21
- Joined: Fri Jan 14, 2011 6:53 am
Unread post
by kotlas »
remi77 wrote:Hi Kotlas,
No, it's impossible to complete this list,
See you,
Rémi
Hi Rémi
I want to read information from the PP (table is from VB6) and putting it in tool list.Is it possible?
-
Attachments
-
-
remi77
- Administator
- Posts: 348
- Joined: Thu Feb 22, 2007 10:05 am
-
Contact:
Unread post
by remi77 »
Hi,
I'm not sure to have clearly understood, but if you to add your tool list in your block file,
Open your *.ini file.
Go to section [MYDEFINE_PROGRAM,BEGIN]
an add :
#bloc = MSG,[DEFINE_LIST,TOOL];
I urge to you to clearly define what you want
See you
Rémi
-
kotlas
- Corporal
- Posts: 21
- Joined: Fri Jan 14, 2011 6:53 am
Unread post
by kotlas »
remi77 wrote:Hi,
I'm not sure to have clearly understood, but if you to add your tool list in your block file,
Open your *.ini file.
Go to section [MYDEFINE_PROGRAM,BEGIN]
an add :
#bloc = MSG,[DEFINE_LIST,TOOL];
I urge to you to clearly define what you want
See you
Rémi
Hi
I want to transfer information from this table to the tool plan
-
Attachments
-