[Solved] putting rebates onto a radiused bottomed panel

CADCAM machining solution: mill-turn centers, milling and turning, kinematics, fixtures, topology recognition, tool library, manufacturing schedules, realistic simulation, workshop sheets, post-processors and DNC...

Moderators: remi77, jacs, Daniel

Dave
Private
Private
Posts: 7
Joined: Mon Nov 15, 2010 3:37 pm

[Solved] putting rebates onto a radiused bottomed panel

Unread post by Dave »

Help needed with this one.

I am trying to put a 6mm deep rebate into panel that is radiused at the bottom the lines in the pic represent the rebates.

Thanks

Dave
Attachments
chloesbathroom.jpg
Dave
Private
Private
Posts: 7
Joined: Mon Nov 15, 2010 3:37 pm

Unread post by Dave »

not to worry all sorted now :D
Post Reply