Page 1 of 1

[Solved]DME Stop Pin Improvement!!!!

Posted: Thu Dec 30, 2010 5:58 pm
by Bill
Hello everyone,

A short time ago, I was having a discussion with the TopSolid'Mold development team regarding DME stop pins. The discussion went something like this:

I have polled all of my customers regarding the H value (head thickness) of the DME Stop pins. I understand that the pin is shipped from DME at a head thickness of .203in. However every customer changes it to be .1875in. Can you modify the library to reflect this permanently? Or add an optional “trimmedâ€

Posted: Fri Jan 28, 2011 5:13 am
by Larry M.
What? :shock: After 5 years? lol Nice to hear, that has been a pain forever.

Did they get rid of the double dimension it creates with DME stop pins using Mold Location too? :P