I think it would be very handy if there was a way to put a parameter driven toggle for any process for a part. So you could activate or deactivate a...
Is there a way to open Solidworks Assembly files (xxx.SLDASM) in Top Solid? I can open most individual solid files but haven't been able to open any...
Last post
I think Missler should supply it as default.... as many other softwares...
I draw 2 circles that tangent from each other with diameter 20 mm. The dimension outside to outside is 40 mm but is yellow. That I can use him in an...
Last post
You can create a parameter based on a distance or a dimension.
Use the bue parameter function. (Next to the blue point).
I just got my full 64bit system up and running and found out that 3Dconnexion does not support the serial port Spaceballs for it. So off to the store...
Last post
I was at 228 but I'm now at 232. Still same result, moving the part with the spacepilot does not work. Any key commands I set up work though. And it...
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot post attachments in this forum